INSTRUCTIONS

TILES

1. Cut the nozzle (A) about the same size as the wiper (B). Put sealycone on the nozzle and pull the trigger on the caulking gun until you can se some silicone coming out in the chamber (C)






2. Start in a corner and work in the same direction as the arrow. It is important that sealycone closes tightly against the surfaces to get the best results.

A good rule of thumb is to hold Sealycone with one hand and the other hand on the trigger.





3.  As long as you see that material comes out of the chamber, move the caulking gun in the direction of the arrow. Do not worry if you don´t get enough material, you can always go back and correct...as many times as you like. If you get too much material, clean Sealycone with paper or a cloth and pull it over the area you want to correct without toching the trigger on the caulking gun. This removes excess material.

You never need to use masking tape or any other messy caulking tools again...

INSTRUCTIONS

WINDOWS

1. Cut the nozzle (A) about 8 mm in diameter . Put sealycone on the nozzle and pull the trigger on the caulking gun until you can se some material coming out in the chamber (C)






2. Take 2 clamps and one wodden strip and fasten it parallel with the window frame to get a support for SEALYCONE. Lay the putty tube in varm water for 10 minutes before use, to make it more soft and easier to work with. It is important that sealycone closes tightly against the surfaces to get the best results. A good rule of thumb is to hold Sealycone with one hand and the other hand on the trigger.






3. As long as you can see that material comes out of the chamber, move the caulking gun in the direction of the arrow.. Make sure Sealycone closes tightly to the surfaces and pull the trigger.... It´s as simple as that...Don´t worry... You can always go back and correct if you missed a spot...as many times as you like..